talkshilt.blogg.se - Ipass virginia

Ipass virginia serial#
Ipass virginia license#

Also, the following glass features may interfere with the E-ZPass signal and require alternative or exterior mounting: solar ray, solar tint, heated, heat reflected, insulated, Insta-Clear. In general, windshields that contain metal in the glass (metal oxide) and mirrors with compass or temperature readings may prevent the E-ZPass signal from being read properly.

Ipass virginia license#

Some vehicles have special features that require an exterior License Plate Tag (LPT) or alternative placement. Mounting for Vehicles with Special Windshield Features Kansas Maine Maryland Massachusetts New Hampshire New Jersey New York Ohio Oklahoma Pennsylvania Rhode Island Texas Virginia Washington West Virginia. Please note: Your E-ZPass license plate tag should be attached to the center of the front bumper, even if your license plate is in a different location.Tighten the bolts securely, but do not over tighten. While I-PASS is still the best, most cost-effective way to pay tolls on the Illinois Tollway, Pay By Plate is built on the I-PASS payment platform, giving you a range of payment options while ensuring you avoid costly fines and fees, all without a transponder. Fasten your E-ZPass tag to the front license plate using the existing top mounting bolts and the knock-out holes at the bottom of the E-ZPass tag, so you do not cover the state name on your license plate.This side should face inward to your vehicle. It will have the sticker with the Maine Turnpike Logo. Identify the flat side of your E-ZPass tag.You may order additional mounting strips by calling E-ZPass Customer Service atġ-888-MTA-PASS (1-88), Mon-Fri, 8 AM-6 PM An extra set of mounting strips was provided with your E-ZPass order. Please note: Do not try to remove the mounting strips from your windshield and reuse them.

Your E-ZPass tag may be removed by gently lifting one corner of the tag to separate the adhesive strips.

Place the tag in the correct position and press firmly against the glass for 15 seconds to achieve a good bond.

Turn the tag right side up facing you.

Without removing the second set of adhesive strips from the tag, carefully remove the protective backing from the mounting strips on the rear of the tag.

There are four adhesive strips: two are permanently mounted to the tag, and two are for mounting to the windshield.

If your vehicle has tinted glass, make sure the device is at least 1 inch below the tinted section of glass.

Locate the correct position for the tag - the upper center portion of your windshield behind the rearview mirror, at least 1 inch to the right of the mirror and at least 1 inch below the top edge of the windshield.

This side faces the interior of the vehicle with the arrows on the tag pointing toward the roof.

Ipass virginia serial#

Identify the front face of your E-ZPass tag (it will have the label with the Maine Turnpike Logo and the tag serial number).

Clean and dry the inside of your windshield around the rearview mirror.

Vehicles with Special Windshield features.

Standard windshield and license plate mounts.